Hello, I installed an interior light in the hatch. The harness was already there, but I can't find the option on the list to activate it. Can someone tell me which option activates it?

Hi, I have a MY2023 XC40 Plus with front sensors + back cam and back sensors.
The sensors “closest” setting starts beeping way too far from the obstacle and parking in tight spaces is very tricky.
I saw 360 cameras can be calibrated, can sensors do the same? So they start beeping closer to the obstacle?

Thanks

Hi, I have full ambient lighting inside ( door pockets, foot well, above the wood trims, on door handles etc… ) and I’ve found this kit on AliExpress ( Kit ). Would installing them be a matter of switching the old ones with the new ones or do I need to plug / reprogram anything? 

Thank you

Hi, does someone know if the two small ceiling LEDs are just white or maybe by changing some settings I can make it different colors? Like in older Volvo models.

Hi everyone, 

I hope you’re all doing well!  I recently bought a used WAM from eBay and installed it along with four cameras in my 2020 XC90 PHEV. I set up configuration item 154 (Parking Camera) using option 6 for the Parking 360 Cam. The good news is that the 360 view is working, but it does need some calibration, as you can see in the photo below. 

   


I’ve been trying to calibrate the 360 camera using the Orbit service for Park Camera Calibration, but the option appears grey and I can’t activate it. I've also tried reloading the car profile and disconnecting and reconnecting to the vehicle, but no luck so far. If anyone has encountered a similar issue or 

   

has any tips to help me out, I would really appreciate it! 

Thanks so much,

 Farhat

Hi Everyone;

Recently had a issue with my 2016 XC90 as water got into the passenger footwell and found that the WAM (Parking Control Module) was corroded. I did clean up the board and the wires but it seems the Camera's aren't working and the City Safety message is coming up so was wondering if I need to get a new WAM (Parking Control Module) and what would I need to do? Can I just plug and play the new board or would I need to purchase Orbit in order to do so?

Much help would be appreciated thank you!

Hi,

Is there anyway to force an upgrade to the car, besides going to the dealer (they probably charge for this?)?

App says I'm on software 3.3.16 and that 3.4.4 is available from 10 February 2025 and should be available around 3 weeks after this over the air

If I check in the car he says I'm on the latest software with 3.3.16

Hi All,

I have a base model 2024 Polestar 2. I'm trying to figure out if wiring is present in the base harness for any of the following:

• Interior/Exterior Air Quality Sensors
  
• Trunk Foot Sensor
  
• Fog Lights
  
• Dashboard Trim Lighting
  
• Center Console Trim Lighting
  

Hi there,

Happy Orbit user here. I drive a 2023 XC40 Recharge (single motor, low range, no ACC) and have used Orbit to enable ACC.

So far it's going well, but I do get a lot of "Hold Steering Wheel" Warnings, especially when cruising on the Autobahn. I am holding on to the steering wheel, but just not "hard" enough to satisfy the car.

Is there any chance to change the sensitivity for this maybe?

Thanks in advance!

The China market has blocked USB drives in AAOS to force us subscribe the car data to listen to music.Is there any ways to unlock the developer mode in Android or install third parties app in other ways.