Or is it displayed somewhere else?

A question about Volvo's three-flash turn signal: in the settings, in point 104, you can choose standard or sequential. Is there any way to change the number of consecutive ones from three to, for example, four?

If it can't, do the application developers have an idea how it _maybe_ could be changed? I missed this from the Skoda (VAG group)+VCDS combination, which made it really easy.

Hi all. 
Did anyone successfully restored original mileage on xc90 2016. 
After cluster replace, car took highest mileage from cluster.
Any info will be great, thx in advance ?

I'm planning to buy the acceleration boost for a polestar 2. Has anyone done this while having some changes applied with orbit (pixel lights enabled + backup cam 360 by default)? Were there any issues doing the accel boost OTA?

Wanted to give my experience with enabling Pilot Assist 2, at least I believe that's what it is. I have a MY16 XC90 with factory installed Pilot Assist 1 that works up to 30 mph and requires a lead vehicle. I used the config preset option in Orbit to select level 2. The two config items that changed were 023 and 145 (see attached picture). I already had 38 - Top Damping Brakes enabled from factory. 
I can now use the PA up to 80 mpg, no lead vehicle required. When it's activated I get a green steering wheel icon below the speedometer, which wasn't there with PA1. I only tried this for about 20 minutes or so yesterday. It worked fairly well for me on highways, except in construction zones where the lines weren't clearly marked. On side streets, even where clearly marked lines, it worked ok but seemed to wonder between lines a little much and I wasn't as confident with it staying in my lane. 

Właśnie się uczę. Nie mogę zaprogramować nowego kluczyka lub czy jest na to jakiś inny sposób

Attached Files

Thumbnail(s)
   

I just changed option 312 Lane Change Assist to level 1, but I have no clue what it does?

Does it change lane when you turn on the flashers during cruise control/pilot assist??

hi, anyone can connect to Volvo vida and update my car via remote desktop?

2021 xc60 polestar engineered 

After many many issues (because I was using a virtual machine via a Mac) and Power6 stepping in at all hours of the night and morning. I actually had to load a 27inch monitor and full atx chassis into my car for him to recuse me from a BRICKED car (again, my fault not Orbit) I’ve set my speed limit to 190 (hit 157 today on a track) and updating my wheels due to 21’s for winter and 22’s for summer. I was in tinkering mode.. as I’ve already accomplished what I got orbit for. 

Enter 109 “adaptive (and bending via another config #)  I now have fully operating ACTIVE HIGH BEAMS. 

Was just driving in a lot of traffic, and after almost a 20 minute drive with my active highbeams on most of the time, nobody flashed me not once, and I saw how they lit up part of the road and part of the other road was not lit just adjusted as it needed based on oncoming traffic. It seems vehicle speed is also part of the algorithm.

When the engine is not running, the speed icon in the turn glows green as soon as the engine is started, a yellow triangle appears, which means this icon, how to remove it from the screen using orBit

Attached Files

Thumbnail(s)