I did install original camera + original wiring

after install i did use orbit 154 + config 9

on center screen i see camera icon but its greyd out and when turning reverse nothing popsup on?

do i miss some config or what

Hey there, is there any way to send the headlight leveling calibration command via Orbit? Ever since enabling and disabling adaptive high beam my driver's side headlight is pointing down significantly. No new errors but I can't seem to get it to self-level. I haven't hit anything and there's no DTC when set to defaults.

after swapping srs unit from another car (for testing only), abs lost acceleration yaw sensors calibration, anyone knows how to calibrate them again?  

is it done with specific test drive, or need do it via diagnostic?

Has anyone retrofitted AIRBORNE PARTICULATE MATTER SENSOR (APMS)  part number 31497671 ? 
I checked the wiring it's pretty simple.  It is actually connected to CEM and not the CCM as I thought. 
A1 > goes to power CF 14 on the fuse box
A2 > goes to CEM (IP connector )pin 15. 
A3 > goes to ground.  

The question is that Does the HVAC require something additional like a cleaner or different filter?

Is it possible to cut all the lights front/rear except brake lights on the switch with OrBit?

Hi!

Hi! Just picked up my 2024 xc40 plus trim with pixel option, Was surprised to see that it doesn't have the active bending lights like my xc60 had. is it more subtle now or did they remove it?

I enabled the pixels with orbit, as well as the auto high beam on all the time, but was shocked to see they don't bend like my 2021 did.  

"I've acquired a Volvo C40 and am curious if the Android ID system allows for the adjustment of the odometer readings?

Hey everyone,

I have a MY22 B6 engine and it lacks the Eco drive mode found in earlier model years. In my CC, only Comfort or Offroad are available.

I was thinking if there are configuration changes that can be made via Orbit to improve MPG like turning off the supercharger as I don't need the extra power most of the time.

Hi!

First of all - thanks for your work on SPA programming!

Before I buy - i Wonder if it's possible to reset VCM module by triggering the same reset process as in VIDA Advanced test?


Having issues with VCM (gps position, WiFi e.g.) on my 2017 V90.

   

I have powered tailgate and back sensors, would it be possible to configure hands free tailgate open by leg movement in front of the bumper sensor?