Hello Friends, I changed the HCMR module in a volvo xc60 2019 (old damaged) I need SBL and VBF files to encode. HW module 31427777AE identification HCML HW31427777AE SW1:32293837AA SW2:32293838AA SW3:32133950AA Thank you very much for helping me

For 001, we have now 7 values with proper description.

Help us find the missing ones, certainly we have XC60 and XC90 here, probably Polestar 1, soon EX90, etc.
Can you check your 001 value and let us know here?

I am just playing around with Orbit again as I have a service appt soon, so yesterday, I clicked the "Restore to OEM" button.

I'm expecting the dealer to tell me that I'll need a new battery for my 2019 S60 and I see that some functionality to report/reset battery service life has been added.  Way cool - now I can do the job myself.  So, today, I went back out to the car to see what the battery counter is before anything happens at the dealer and it tells me that "Current 12v Batt Days In Service: 1"

I'm confused, did "Restore to OEM" reset the battery counter as well?  Or did I do something wrong?

Thanks,
Eric

Attached Files

Thumbnail(s)
   

Hello everyone,
Is there a way to activate the center speaker from HK or B&W on high performance?
I connected it to pins 2 and 10, but there is no sound. You can only hear minimal noise when you hold the speaker to your ear.
Thank you very much.


Gesendet von iPhone mit Tapatalk

Greetings from cold weather!

I wonder if there is any setting for the runtime of the Webasto heater. With the help of Orbit and advice on this forum I have manged to get the Webasto heating the engine also. However, the default runtime for the Webasto is only ½h and that is not quite enough if the outside temperature is below -20deg C. I remember that Volvo pre 2019 could run their Webasto for almost an hour.

Can the preheating Webasto runtime be changed with Orbit somehow?

   

Does anyone else have this problem when trying to save the config or DTC .txt files in Orbit?

Hi,

Anyone know what raw command should be sent to CCM in order to remove a CPM lockout?

Hello
Just found this comunity and dont know much about Orbit SW.
I`m searching a way to read fault codes and other information but I also want to add Sensus navigation (now I have only internet navigation) and also androidauto and apple carplay.
I dont have PIN. My car is V90 2017/10.

Can this be done with Orbit and what wersion I need to buy?

Thank you for help!

I ran into a minor dealer issue today when I went in for a state inspection. The emissions logging didn’t have sufficient sample data to pass inspection, which I suspect was related to the reset sequence. I just need to drive it around for a few hours on the ICE but wanted to mention it for others. Has anyone else here with the PHEV drivetrain seen this?

I'm having some issue with sourcing group H7 battery locally (what came with the car), but most stores have the bigger group H8 battery in stock.
I know this is a supported battery size in CEM "H8 AGM Exide 95Ah 850CCA", so I'm just wondering is there more to changing the battery size than changing the config in CEM?

VIDA product specification is a little unclear on how the charging circuit works, my understanding is that the CEM takes reading from BMS and then it can command alternator control module to change the supply base on the charging algo determined by the CEM?

I think the H8 battery is about 15ah bigger than the H7 capacity wise, I suppose it might be fine if I just leave it as it, but I figured if I am doing it, I want to do it right.

Thanks in advance.