Hi Everyone;

So have a 2016 XC90 and got some issues here:

1. Can't read the cars computers with my Autel diagnostic tool even tried another one which have both worked before in the past?

2. Driver and passenger seat won't adjust.

3. On the dash "Service driver support system" & "City Safety" messages come up?

There was water in the passenger footwell hence I just replaced the WAM and fixed some corroded wires but I am at my wits end here trying to get this car up and running!?

Any help would be appreciated!

Hello, I have a 2023 xc 40 and I have a problem because when I stand still it discharges my battery
It starts the mass relays every few minutes, mass er02 and er013 appear
I wanted to know how it is built, only when I stand still I can hear the ABS pump and throttle valves

Hi
i am going to service my Volvo XC60 D4 2020 at a local volvo dealer and wonder
if some one could help me with a guide to store my settings before the service.
And how to restore it after the service.
tnx
Ulf from Sweden

Has anyone encountered such errors?
**OrBit DTC Report for YV4L12UW1P2088945 (last read: 2025/04/03 08:00:47)**

CEM-B14C281 - 2025/04/02
  Head Lamp Input- Bus Signal / Message Failures- Invalid serial data received

CEM-B18711B - 2025/04/02
  **No description found in ECU database**

HCML-B161421 - 2025/04/02
  Headlamp Control Module LED Channel 6- General Signal Failures- Signal amplitude < minimum

HCML-B161022 - 2025/04/02
  **No description found in ECU database**

HCMR-B161421 - 2025/04/02
  Headlamp Control Module LED Channel 6- General Signal Failures- Signal amplitude < minimum

HCMR-B161022 - 2025/04/02
  **No description found in ECU database**

Hello, I installed an interior light in the hatch. The harness was already there, but I can't find the option on the list to activate it. Can someone tell me which option activates it?

Hi, I have a MY2023 XC40 Plus with front sensors + back cam and back sensors.
The sensors “closest” setting starts beeping way too far from the obstacle and parking in tight spaces is very tricky.
I saw 360 cameras can be calibrated, can sensors do the same? So they start beeping closer to the obstacle?

Thanks

Hi, I have full ambient lighting inside ( door pockets, foot well, above the wood trims, on door handles etc… ) and I’ve found this kit on AliExpress ( Kit ). Would installing them be a matter of switching the old ones with the new ones or do I need to plug / reprogram anything? 

Thank you

Hi, does someone know if the two small ceiling LEDs are just white or maybe by changing some settings I can make it different colors? Like in older Volvo models.

Hi everyone, 

I hope you’re all doing well!  I recently bought a used WAM from eBay and installed it along with four cameras in my 2020 XC90 PHEV. I set up configuration item 154 (Parking Camera) using option 6 for the Parking 360 Cam. The good news is that the 360 view is working, but it does need some calibration, as you can see in the photo below. 

   


I’ve been trying to calibrate the 360 camera using the Orbit service for Park Camera Calibration, but the option appears grey and I can’t activate it. I've also tried reloading the car profile and disconnecting and reconnecting to the vehicle, but no luck so far. If anyone has encountered a similar issue or 

   

has any tips to help me out, I would really appreciate it! 

Thanks so much,

 Farhat

Hi Everyone;

Recently had a issue with my 2016 XC90 as water got into the passenger footwell and found that the WAM (Parking Control Module) was corroded. I did clean up the board and the wires but it seems the Camera's aren't working and the City Safety message is coming up so was wondering if I need to get a new WAM (Parking Control Module) and what would I need to do? Can I just plug and play the new board or would I need to purchase Orbit in order to do so?

Much help would be appreciated thank you!