Hey everyone, I'm a bit new to here so I don't know how things work. I bought OrBit subscription with CEM Pin crack service. I've sent mail to the support but no one replied yet.

Also how do I register my mail so I can use the orbit software?

Hello everyone!

I installed new bumpers on my Volvo XC90 2019y (inscription)  fron R-Design car 2020y
But the parking sensors don't work. 

I tried to replace the PAM. My number PAM 32243137, new 32281512
but, it didn't work

I was told that I need to replace the parking sensors because they were not the same in 2019 and 2020

Maybe someone knows how to fix this without replacing the parking sensors ?

Is there any settings in orbit to disable the mood lighting in the rooflights especially the little rings around buttons 2+4. I know you can dim by using the roller at the side of steering wheel but it's not enough.

Sent from my SM-S711U1 using Tapatalk

座椅通风按摩加Can it be modified


座椅通风按摩加热

Hi there,

A noticed an slight increase on SoH of the PHEV Battery (10.8 kWh model / 6 years old). Current report 83,1% and last report 82,7% months back. I am little surprised and I guess I should be happy it reached some sort of stable level.

Can you share anything on how Orbit retrieves or calculates this value?

I also found VIDA has been upgraded to compute and generate SoH certificates from MY21 onwards, so Volvo modified their SoH calculations probably too. Can you state something about this too? Orbit probably is more close to the legacy calculation of VIDA?

Thank you.

I posted this on the XC40 Recharge subreddit, but I want to give praise to Orbit here.

3.7 tried to brick me; Orbit saved the day!

I have a ‘21 P8, and I applied the 3.7 OTA update and it claimed to install successfully. The next time I went to drive my car after the update, it screamed with every warning possible and ultimately left the message “Stop Safely Brake Failure”. I had no driver aids and no regenerative braking. Fortunately the friction brakes worked.

I do the typical reset a few times with no luck. Then I remembered I have Orbit and decided to just try “Restore to OEM” despite having my car already set to OEM. Then MAGIC! Well, actually about ten minutes of suspense while I watch the car reset and reset and reset (which the Orbit programming sometimes does). But then finally it boots back up and all my errors are gone and my car is back to normal!

I wish Volvo’s software wasn’t so awful. But if you run I to this stuff, and have Orbit, you might be able to save yourself a trip to the dealer. YMMV but I’m glad I have it.

Hi all,

I’m using Orbit with my 2016 XC90 T8 (SPA platform). I would like to know if Orbit can directly read out specific PIDs, such as:

- Hybrid battery State of Charge (SoC)
- Electric range
- Charging status (AC/DC, power)
- Climate control / heater status

So far I’ve been experimenting with WiCAN and MQTT → Home Assistant, but I’d prefer to use Orbit if it can decode these values more easily (without having to sniff all CAN frames myself).

Can Orbit access these PIDs directly, or is it limited to diagnostics (DTCs, service functions)? And if possible, is there documentation or a module/DB available for SPA cars?

Thanks in advance!

Good morning,

is that normal?

I only use OrBit to unlimit the 180 km/h. Every time I do so or revert to OEM before update and service, after configuration the trailer service notification comes up and I can't release the hitch. Only after deleting all errors and rebooting all ECUs, the hitch is working again.

The car is a 2024 XC90 T8.

Cheers
tobala

Hello all from Spain. 

I am new to the forum, I am waiting to receive a 2021 T8 s60 and I came across this software but I have some doubts. 

I am quite into changing configs in all my cars (hondata, vagom, etc) but never had a Volvo before.

I have been taking a look at the orbit configs and I am wondering:

If I dissable passenger hood pop from orbit but the car has it installed, in case of collision will they be fired? A friend of mine had a small crash against a bush and the hood popped up and he had to pay about 2k € to replace them and had the car unusable for months. So I would like to disable it.

Also, has anyone succeeded in adding front camera? My car only has a rear view camera but I would love to have the front one too.

Thank you all in advance

Hello, can orbit clear errors from the BECM module?