06-05-2025, 06:55 AM
Or is the same pins for subwoofer and amp side?
Retrofit Subwoofer on High Performance w/o Subwoofer
|
06-05-2025, 06:55 AM
Or is the same pins for subwoofer and amp side?
08-09-2025, 03:38 AM
(This post was last modified: 08-09-2025, 05:47 AM by Kenn.
Edit Reason: Clarifying
)
(02-07-2024, 04:04 AM)IMAY2023 Wrote: Just go ahead and try. 2021 v60 D4 momentum I have high performance audio without sub and no center speaker on dash. My amp has 5 fins Do you mean I should use pin 2 and 10 for sub when you say second pin from right or do you mean that they are for the center speaker? Pin 7 and 15 are taken, driving Right rear and tweeter. According to this link. See post 16. Also, what impedance is correct for an aftermarket sub and my 5 fin amp? I have optical, power/rem and then one 16 pin connector. Thanks in advance
I also have V60 2021 without subwoofer. Amp and wires looks like this:
https://ibb.co/Mym9G2rF https://ibb.co/zhhZXvK1 I haven't found solution how to connect sub to this amp. Or is it even possible without aftermarket amp..?
08-27-2025, 12:29 PM
(08-27-2025, 11:45 AM)Hannu Wrote: I also have V60 2021 without subwoofer. Amp and wires looks like this: I think the empty pins (6/14) between the green lines is the output for the sub. If enabled with orbit you can use a voltmeter to se if there is any juice. About 2 volts on the pins I think. Or just connect a speaker. However the amp is weak (about 1/4 of power compared to the Harman Kardon amp) so maybe it won't be enough for full subwoofer performance. In that case, connect an extra amp thru high level in to amp and then to the subwoofer. Let me know how it goes?
09-08-2025, 03:52 PM
Thank you. I'm waiting subwoofer and amplifier now. Lets see how it works.
Sub is 4ohm (HK) and amp is soundigital 400.2 with hilevel input. I let you know results when I'm done.
09-08-2025, 03:53 PM
(09-08-2025, 03:53 PM)Kenn Wrote:(09-08-2025, 03:52 PM)Hannu Wrote: Thank you. I'm waiting subwoofer and amplifier now. Lets see how it works. Yes, that's my plan. I activated sub using orbit but there is no signal at all. I tried both of free pins without luck. Using voltmeter and speaker -> nothing. I got subwoofer level adjustiment on sensus but that's all. Tried lock doors for 10 minutes, also tried reset AUD and IHU using Orbit. So maybe there is no output for subwoofer in this model of amp. Next I should find out which wired goes to front doors woofers. Does anybody have wiring diagram for amp like this (5 fins top of amp)? Maybe I have to crap signal there.
Yesterday, 02:33 PM
(Yesterday, 01:00 PM)Hannu Wrote:The sub channel is dead since an update in about 2020. I pm:d Andrew about reverting AUD-software but no respons yet. I guess his plate is rather full ?(09-08-2025, 03:53 PM)Kenn Wrote:(09-08-2025, 03:52 PM)Hannu Wrote: Thank you. I'm waiting subwoofer and amplifier now. Lets see how it works. I'll attach the speaker output scheme. Pin 3/11 and 4/12 is front woofer I think Where are you getting you're REMpower? Or does your amp come with high level on? Good luck |
« Next Oldest | Next Newest »
|