Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Polestar 2 charging port US-EU
#1
Hi, anybody has attempted to do type1 to type2 charging port swap? I know that it can run on Factory OBC(charger module). Maybe some of you attempted to do this and have working 3-phase charging. I see on config position number 029 but maybe modules need to be flashed or sth. I Think same procedure will apply to every EV and PHEV vehicles.
Reply
#2
Did this yesterday - Type2, but cable from charging port to battery has to be replaced with European one. Do not ask me how to replace the cable - it has been done by the customer itself, my role was just to make the car European Wink
Reply
#3
Yep i know that i need to put battery off vehicle. So it’s just edit in config and 3phase type 2 is working?
Reply
#4
(10-24-2024, 06:52 AM)kaska3er Wrote: Yep i know that i need to put battery off vehicle. So it’s just edit in config and 3phase type 2 is working?

yep
Reply
#5
i have also done this conversion a week ago. Lowered the battery and changed the cable. a lot of work but its working as it should.
Reply
#6
I have a problem with the charging power in my Volvo XC90 T8 2022 USA, imported to the EU. I changed the charging socket from type 1 to type 2. In the OBC diagnostics, it correctly detects the charging cable as 16A, but it only charges with a power of 9.5-9.6A at 230V, giving me a maximum of 2.2-2.3KW. Is there a way to adjust this? Do I need to change something in the configuration or reload the OBC? (between PP and PE is 680 om - show as 20A )
Reply
#7
You have to replace the cable from charging socket to battery with eu one. Type 2 for eu is ok. No obc replace or reload is needed. At least for Polestar 2 and xc40 it is working
Reply
#8
thanks, the problem is with FEYREE chargers which have a poorly selected resistor between PP and PE, after tuning it everything works correctly on one phase

does anyone have a diagram of how to connect a two-phase charger? to charge with 400V current to type 2 connector without pin L2 and L3?
Reply


Forum Jump:


Users browsing this thread: 4 Guest(s)