OrBit Forums › Diagnostics and Maintenance › DID - Data Reading by ID
Engine code

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Engine code
przemek219 Offline
Junior Member
**
Posts: 15
Threads: 5
Joined: Feb 2024
Reputation: 0
#1
06-12-2024, 09:26 AM (This post was last modified: 06-12-2024, 12:19 PM by przemek219.)
Czy można gdzieś w programie odczytać kod silnika?
Is it possible to read the engine code somewhere in the program?
Find
Reply
IMAY2023 Offline
Senior Member
****
Posts: 551
Threads: 8
Joined: Feb 2023
Reputation: 50
#2
06-12-2024, 04:09 PM
(06-12-2024, 09:26 AM)przemek219 Wrote: Czy można gdzieś w programie odczytać kod silnika?
Is it possible to read the engine code somewhere in the program?

If you are talking about ECM "Engine control module" trouble codes "DTCs", yes you can.  You can also clear them. However, some trouble codes will come back after clearing them such as "P0171 - System Too Lean (Bank 1)"  because it requires to clear the adaptations.  A work around for this, pull out the battery negative port at least for an hour.
Find
Reply
danthe88 Offline
Junior Member
**
Posts: 48
Threads: 1
Joined: Nov 2023
Reputation: 1
#3
06-12-2024, 07:09 PM
Mislim da on zeli da procita broj motora.
Find
Reply
przemek219 Offline
Junior Member
**
Posts: 15
Threads: 5
Joined: Feb 2024
Reputation: 0
#4
06-13-2024, 02:13 PM (This post was last modified: 06-13-2024, 02:14 PM by przemek219.)
I mean exactly the engine code and not the b420t2 errors
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)