Hello everyone,
I wanted to ask whether it is possible to apply configuration changes through the wizards without clearing or resetting the DTCs.
I currently have an intermittent “Reduced engine performance” issue that needs to be diagnosed by the dealer.
When I read the codes myself, I found P200900 confirmed and P00BC00 stored.
The car also consumes quite a lot of oil, so I suspect the issue may be related to the EGR valve.
Recently, I disabled the ACC that I had previously enabled through Orbit, but doing so cleared the DTCs. Since then, the reduced engine performance warning has not appeared again.
It would be very useful if I could disable and re-enable features until my dealer appointment, which is in about a month, without losing any diagnostic data. I travel a lot, so I would really like to keep using ACC in the meantime if possible.
Is there any way to apply wizard changes without clearing the stored/confirmed DTCs?
I wanted to ask whether it is possible to apply configuration changes through the wizards without clearing or resetting the DTCs.
I currently have an intermittent “Reduced engine performance” issue that needs to be diagnosed by the dealer.
When I read the codes myself, I found P200900 confirmed and P00BC00 stored.
The car also consumes quite a lot of oil, so I suspect the issue may be related to the EGR valve.
Recently, I disabled the ACC that I had previously enabled through Orbit, but doing so cleared the DTCs. Since then, the reduced engine performance warning has not appeared again.
It would be very useful if I could disable and re-enable features until my dealer appointment, which is in about a month, without losing any diagnostic data. I travel a lot, so I would really like to keep using ACC in the meantime if possible.
Is there any way to apply wizard changes without clearing the stored/confirmed DTCs?