+- OrBit Forums (https://forums.spaycetech.com)
+-- Forum: General (https://forums.spaycetech.com/forumdisplay.php?fid=1)
+--- Forum: OrBit Q&A - Ask your questions here! (https://forums.spaycetech.com/forumdisplay.php?fid=24)
+--- Thread: Wizard configurations without DTC reset (/showthread.php?tid=1375)
Wizard configurations without DTC reset - Decked - 07-03-2026
Hello everyone,
I wanted to ask whether it is possible to apply configuration changes through the wizards without clearing or resetting the DTCs.
I currently have an intermittent “Reduced engine performance” issue that needs to be diagnosed by the dealer.
When I read the codes myself, I found P200900 confirmed and P00BC00 stored.
The car also consumes quite a lot of oil, so I suspect the issue may be related to the EGR valve.
Recently, I disabled the ACC that I had previously enabled through Orbit, but doing so cleared the DTCs. Since then, the reduced engine performance warning has not appeared again.
It would be very useful if I could disable and re-enable features until my dealer appointment, which is in about a month, without losing any diagnostic data. I travel a lot, so I would really like to keep using ACC in the meantime if possible.
Is there any way to apply wizard changes without clearing the stored/confirmed DTCs?
RE: Wizard configurations without DTC reset - x119 - 07-03-2026
If you don't clear DTC which are caused by configuration changes then the features won't work and you'll be left with a car that doesn't function correctly (notably ABS). So TLDR on this is; nope.
RE: Wizard configurations without DTC reset - Decked - 07-03-2026
Aye thanks