First config change to S60 MY23 worked fine but result partially

[Power6]

• 043 Max Vehicle Speed Limitation from 180 to 250 (untested, not possible yet)
  
• 096 Audible Locking Feedback set to On (unfortunately not working) 
  
• 271 Start/Stop Function Memory set to “Button without memory, standard symbol” (I don’t know where to find the switch.
  The car still turns the engine on/off as expected with this setting, but where the hell is that switch/button in the menus?)
  
• 374 Polestar Level set to “Polestar optimized” (had a short drive, can’t say much yet). 
  

I got your message to support, so we will work out if there are any specific issues, like the speed limiter setting should absolutely work! I will make some notes though, for other following here, some of the issues here we know. First this is assuming settings are confirmed by connecting to the car in OrBit, and check the config read from the car matches what you changed. If the config wasn't written, then that is some different issue like a config flashing failure.

Audible locking feedback - It requires the car has a BBS module, which is the alarm siren. That is in the car if it is equipped with an "alarm" from the factory. If the car is not equipped, then it doesn't have a BBS module, so there is nothing to make the sounds for audible locking feedback.

Start/Stop function memory - This only works for ICE drivetrains in Sensus car. You have the Android MHEV. For this car you can use the "No button - always off" setting to disable start/stop completely. If the car is updated to 5.0.5 system or newer, you can use the "Button - no memory" setting now, to add a temporary disable start/stop slider to the car settings menus. The Config Wizard is helpful here, it only enables supported settings in the radio buttons you can choose.

Polestar Level - effects vary on the cars, some maybe none at all. You should always see the "Polestar Engineered" drive mode in the car settings with this change, you can confirm the config change is actually made. I beleive that is the case on all Android cars, where some Sensus cars were without drive modes.

Speed Limiter we'll look at as a support case with you, there aren't any known limitations as far as the setting working.


FYI on the PHEV, the "230kmh" issue only applies to "Extended Range" PHEV. So not really related here as the OP has an MHEV mild-hyrbid but I will comment on it as it was brought up. It appears to be an "overspeed" warning, not an actual failure like overheating, but a specific maximum RPM soft limit in the ERAD that triggers the "hybrid failure" message that goes away after slowing down, then shut down and restart the car, from what those who can find the limit have told me ;-) We see it varies by the car, some can get up to 250kmh before the warning is triggered. My theory is the tire sizes between models vary the overall gear ratio of the ERAD motor to the road surface, so the speed the warning is triggered will vary. The extended range ERAD does not have a clutch as the previous versions, so the motor in the unit is always spinning at the current road speed as it is permenently engaged.