Wireless Charger install on 2017

[Nazsky786]

Hello,

I’ve installed the wireless charger, but it’s not working.

- I’ve taken the 12V supply from the old cupholder 12V socket (pin 1 positive and pin 5 GND).
- The signal from pin 6 has been connected to pin FL41 on the CEM.
- I’ve set parameter 366 to 04, and also tested option 02.

Do you have option 450 configured?

The button appears on the screen without any errors.

Could you give me any advice or tell me how you have it configured?

Thanks.

If you are sure you have power and good ground at the charger, and also enabled the charger via Orbit, it should work. Only time it doesnt work is if the CEM module fitted to your car is the older version, in which case that would need to be replaced to support it. 

Most cars from 2018 onwards support the WPC so you may have no power at charger caused by blown fuse etc or the signal wire isnt seated correctly at the brown connector on CEM. If you get the part number of the CEM it can be checked.