Volvo V/S90 front seats retrofit/standalone.

[ElMyggo]

I have this code up and running (thanks to the stig) and its working so i have no reason to change anything :-)

My seat are from V90 2018

I use a ESP32C3 mini board with the MCP2515 board and a 12volt to 5v stepdown board, connected like this between esp and mcp:

INT ---not connected
SCK --- 4
SI --- 6  (MOSI)
SO --- 5 (MISO)
CS --- 10 (can be change in the code)
GND --- gnd
VCC --- +5v

i also use a jumper for 120 ohm termination on the mcp board