How to flash a module with software in OrBit

[Nicolicius]

I‘ve Done a flash for the new OEM TRM. 
All Successfull and did a config flash after to go trough the post programming… 

But the AHK won‘t work. 
EU Modell of TRM. 

These are the DTCs 
1. TRH-B14F314 
Trailer Supply Voltage - General Electrical Failure - Circuit Short to ground or open

2. TRH-U2F002 
Lost Communication with CEM - Bus Signal/Message Failures - Alive / Sequence Counter incorrect / Not Updated 

Any Ideas?