12-09-2024, 10:11 AM
so, easiest way I found was to use a hex->dec calculator, then divide the default dec value by 2, convert back to hex and enter that value.. did similar with down
|
ECU command FAILED when trying to set egress seat offsets
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
ECU command FAILED when trying to set egress seat offsets - by hexaust - 11-25-2024, 08:26 PM
RE: ECU command FAILED when trying to set egress seat offsets - by Idle - 12-06-2024, 04:10 AM
RE: ECU command FAILED when trying to set egress seat offsets - by hexaust - 12-09-2024, 03:42 PM
RE: ECU command FAILED when trying to set egress seat offsets - by Idle - 01-25-2025, 03:29 AM
RE: ECU command FAILED when trying to set egress seat offsets - by bananajoe - 12-06-2024, 03:47 PM
RE: ECU command FAILED when trying to set egress seat offsets - by Dave - 12-08-2024, 11:51 AM
RE: ECU command FAILED when trying to set egress seat offsets - by bananajoe - 12-09-2024, 10:11 AM
|
Users browsing this thread: 2 Guest(s)