Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to work with headlamps and HCMs in OrBit (flashing, config, used HCM install)
#15
Hi guys. I have a problem maybe somebody can help me with. Part of my left Thor Daytime Running Light stopped working (white part only, turn signal still works). I tried to swap for a used headlight with same part number, but it had some other problems. After I installed old headlight back another LED ( the one that bends on top) stopped working. My question is which module responsible for what in the headlight and will I be able to reprogram it with Orbit, if I buy a new one? I have 4 modules on my headlight. One small and one black on the rear, one on the side and one on the bottom. I also tried to connect with VIDA and it gives me error messages (circuit short to ground, and missing message e.t.c B1518,B152A,U1322,U1334,U1322,U1051. Thanks in advance.

[Image: B32xq4aoKzRo7qm39]

[Image: B32xq4aoKzRo7qm39]Here is a link to pictures.
Reply


Messages In This Thread
RE: How to work with headlamps and HCMs in OrBit (flashing, config, used HCM install) - by Pavlo - 04-02-2024, 04:09 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)