09-26-2023, 03:59 PM
Hi! This is more of a config question than OrBit question, I might move this to the correct forum, or maybe leave it here for future new users to find ;-)
First if you have "Intellisafe Assist" you should already have Adaptive Cruise(ACC) and Pilot Assist(PA) which is included under that branding?
If you don't have PA/ACC, you can enable it with OrBit. The safety systems in the car already require the same hardware that is needed for PA/ACC. There is the safety camera at the top of the windshield, and if you have a "Sensus" car the radar unit is located there too. On the newer "Android" infotainment cars, the radar sensor was moved to the front grille. Either way you already have those sensors whether you have PA/ACC or not.
There are multiple "items" to set to enable PA/ACC, OrBit has "Config Presets" to make this easier, it picks what should be compatible settings based on the model and hardware config of the connected car. On the configurator tab, click on "Config Presets" and choose from a few different options and apply the settings to the Configurator table. For more info about why there are multiple settings check on this thread: https://forums.spaycetech.com/showthread.php?tid=4
First if you have "Intellisafe Assist" you should already have Adaptive Cruise(ACC) and Pilot Assist(PA) which is included under that branding?
If you don't have PA/ACC, you can enable it with OrBit. The safety systems in the car already require the same hardware that is needed for PA/ACC. There is the safety camera at the top of the windshield, and if you have a "Sensus" car the radar unit is located there too. On the newer "Android" infotainment cars, the radar sensor was moved to the front grille. Either way you already have those sensors whether you have PA/ACC or not.
There are multiple "items" to set to enable PA/ACC, OrBit has "Config Presets" to make this easier, it picks what should be compatible settings based on the model and hardware config of the connected car. On the configurator tab, click on "Config Presets" and choose from a few different options and apply the settings to the Configurator table. For more info about why there are multiple settings check on this thread: https://forums.spaycetech.com/showthread.php?tid=4