First config change to S60 MY23 worked fine but result partially

[jos]

Hi,

Today, I changed the configuration of my Volvo S60 B5 AWD Ultimate Dark MY23 (Volvo UX 5.0.5) for the first time.

These are the settings I modified:

• 043 Max Vehicle Speed Limitation from 180 to 250 (untested, not possible yet)
  
• 096 Audible Locking Feedback set to On (unfortunately not working) 
  
• 271 Start/Stop Function Memory set to “Button without memory, standard symbol” (I don’t know where to find the switch.
  The car still turns the engine on/off as expected with this setting, but where the hell is that switch/button in the menus?)
  
• 374 Polestar Level set to “Polestar optimized” (had a short drive, can’t say much yet). 
  

The flashing process completed successfully and everything looked good—there were some funny noises from the car during the read/write process. 
So, why isn’t the audible locking feedback working? I refer to this: https://forums.spaycetech.com/showthread...65#pid8665
And does anyone have an idea where to find the switch to turn the start/stop system off for the current drive? @BeachBoy?

Orbit ask for profile update (i had a virgin) so it updated and then my changes took place, flashing took about ~2 min afai remember right, everything was smooth.
My battery was only at 63% with 12,6V starting later around 12V, i had a lab power supply connected 13,6V at 20A, the power supply jumped two times from CC to CV so the car sucks a lot  


Best Regards JOS

[jos]

Hi,

today i could test VMax, which i have set to 250, at 185…186 still end.
It feels like that none of config changes worked even when Orbit said flash successfully, i‘ve watched the entire process and everything worked fine.

What can i do?


Best Regards JOS

[Sodertalje]

Hi,

today i could test VMax, which i have set to 250, at 185…186 still end.
It feels like that none of config changes worked even when Orbit said flash successfully, i‘ve watched the entire process and everything worked fine.

What can i do?


Best Regards JOS

If you have a Long Range car with Android (basically MY2022 and newer), do not set the vMax higher than 230 km/h. Driving faster than 230 km/h will result in overheating of the ERAD and put your car in limp mode. It will cool down and reset, but permanent damage can occur in time.

[jos]

Ok, good to know, but this means 250 wont work and its still at the old vmax?

[Sodertalje]

Ok, good to know, but this means 250 wont work and its still at the old vmax?

You can set it at 250, but you'll probably never reach it because your ERAD will overheat above 230 km/h. Use at your own risk. I know someone who did this and was towed to a dealer. Because the process took a long time, the car was cooled down and started as if nothing had happened. The dealer tried to run some updates, and the car was blocked immediately. Modification was not done with OrBit, but you can avoid all this by not setting it higher than 230 km/h.

[jos]

Ok, good to know, i will keep it at 230 instead of 250 but this is all senseless if none of the settings i did are effective. Is Orbit not usable for recent volvo cars or why are not only me finding none change after a config change.

I expected that at leadt pne of the settings i did works but its like i changed nothing.


Best Regards JOS