HP to HK Sound: Door Wires

[thermal-fixity]

Looking at the diagram and the plug it seems like:
- pins A7/A8 are the door plug pins for the woofer channel (I have those pins)
- pins A9/A10 are the door plug pins for the midrange/tweeter channel (missing pins)

So if I understand correctly, the plan is:
- run the wires from the D11/D1 and D22/D10 on AUD to the front doors
- at the doors use A9/A10 pins in the plug (or just run a wire through it)
- and then connect that AUD channel directly to the midrange inside the door (the midrange already has a crossover and is going to pass the signal to the tweeter)

Does it sound right?
Running the wire to the right door should be pretty straightforward, but how did you run the wire to left door?

---

That's what I thought at first

Move D13/D3 to D11/D1
Move D14/D4 to D22/D10

but I realized my D13/D3 and D14/D4 are rear shelf (headliner) speakers. So they are in the correct spot. I essentially plugged back in the old HP AUD and unplugged the whole D plug and all the front speakers were working but not the headliner speakers.

[Marcp]

You only need to run the D11/D1 and D22/D10 cables. You don't need to change anything else.

 The only cables you need to add are those for the ceiling speakers.

[thermal-fixity]

My D13/D3 and D14/D4 wires are color-coded differently. The wire colors correspond to the shelf channel (ceiling speakers):
- Violet/Orange & Gray/Orange
- Brown/Violet & Green/Violet