Wireless Charger install on 2017

[Nazsky786]

Hi,

Ive installed a wireless charger centre console from a 2023, ive used my old loom or else the car wont start and taken the 3 wires from the 2023 loom for the charger but the place where the wires go on the original loom are already populated. 

Where do the 3 wires go as this car isn't supported to have the volvo charger. And on orbit what options do I need to change?

I have red, black and white. I'm guessing the red and black are power and ground but white is control but where do I install that?

Thanks.

---

Also what option do I choose on orbit? There is with on off button but is nfc used?

[IMAY2023]

The red power goes to the fuse box, It has its own 5amp fuse. (you can use a fuse tab) 
The Black is the ground. you can get it from the passenger side under the center console behind the carpet. 
The White one is the LIN communication goes to the CEM.  FL 41.

[Nazsky786]

Any chance you know what options are to be selected on Orbit?

I have Orbit set to;

366 Wireless Phone Charger - 04 Inductive charging for smartphone + OnOff Btn
450 Wireless Phone Charging And NFC - 04 With NFC & WPC

I don't have the option on Sensus to turn on the wireless charging pad so its not working.

Thanks

[IMAY2023]

It depends on the unit you are installing. There are different variants of the wireless charging. 
In addition, the FL 41 pin of the CEM where the wireless unit LIN is connected is empty on some of the CEMs. If your CEM does not have that pin, enabling it does not do anything.

[Nazsky786]

Ok, So the CEM does have all the pins at the FL connector populated, so its connected to something. 

I think its has to do with the configuration as its not turning on the wireless charging pad unless the button on Sensus is there. Which right now its not and I have a invalid config dtc. 

I'm going to try keeping the 450 turned off and and leave 366 as is. 

After a reset see if it does show the button.

[Percy]

Hi!
I am doing the same operation, retrofitting wireless charger on my MY2020 XC60.
Can You please tell med which connector on the CEM is the "FL".
Best regards

[Nazsky786]

Here is the CEM Module FL is the Brown connector,

FYI, Fords was Green from Engine Bay, Brown for Floor Blue for Dash. Seems Colvo carried on this trend.

Q

---

Waiting on Support for help on activation as its not working for me even with High CEM and the opinion choosen on Orbit. WIRELESS charging + OnOff.