Posts: 473
Threads: 42
Joined: Jan 2023
Reputation:
94
Hi! Yes Air Suspension calibration is released some time ago, it's ready for you ;-) You don't need the CEM PIN, but likely the VGM PIN. It's hard to keep track of what the "diagnostic firewall" allows and doesn't allow for service procedures, so for most cases we just assume any service you need the VGM PIN to disable the diag firewall.
It's best to just have the CEM/VGM PINs as long as you keep a car for a while, the PINs do not change so they are good as long as you have the car.
Black Edition...nice ;-)
Posts: 59
Threads: 1
Joined: Mar 2023
Reputation:
1
Do you think it would be possible to add the features to deflate and inflate an air spring? What about showing the current pressures in the air springs? This work is nessecary for doing work properly on cars equipped with air suspension.
Posts: 5
Threads: 1
Joined: Jun 2023
Reputation:
0
02-25-2024, 01:20 AM
(This post was last modified: 02-25-2024, 01:22 AM by Davidoso.)
Just wanted to add something to this thread that might help others: Had some time to test this out today on my 2018 xc60 T8. I got the error message every time I changed the numbers. But I am now 100% sure that all it takes to clear that error (in the dash at least, it’s still present when reading the DTCs) is to drive over 50km/h(about 31mph). After that you can change the drive modes and the car adjusts the suspension. Tried it multiple times, even inside a parking garage where I simply launched the car and stepped on the brakes as soon as I hit 50km/h. It’s amazing what you learn by being lazy.
Posts: 5
Threads: 1
Joined: Jun 2023
Reputation:
0
Does anyone know what the ”original” values are for the suspension? I need to lift mine up but I did a lot of calibration since the rear was always higher up than rhe front, making it look weird. Now I don’t remember what the measurement was to begin with..
Posts: 151
Threads: 5
Joined: Feb 2023
Reputation:
5
Start by just measuring the distances and tell the car the truth about where each wheel is. It should move the to the default positions then.
Sent from my iPhone using Tapatalk