Enabling Pilot Assist and Adaptive Cruise Control

[Synoptic]

Observation for MY21 P2 Launch Edition (Canadian Market) :
When changing ID 149 to 13 (With Speed Limiter), Adaptive Cruise Control becomes unavailable.
Both Cruise control and limit cruise work, but I get "Unavailable" when trying to engage the adaptive Cruise Control.

Have you tried 36 to 03 ASL & AVSL and 149 to OF USA TSI with Speed limiter?


Sent from my iPhone using Tapatalk

Yes, but 149 to the Canadian equivalent.

[sags95]

FYI : I successfully enabled PA and ACC on base model MY22 P2 that did not come with it.

Hi, would be able to share which settings you used?  I have a MY23 P2 that I would like try it out on.


Sent from my iPhone using Tapatalk

Was there another setting you had to change (traffic jam assist?). When just changing that setting I saw ACC but selecting it then shows "unavailable"

[Synoptic]

FYI : I successfully enabled PA and ACC on base model MY22 P2 that did not come with it.

Hi, would be able to share which settings you used?  I have a MY23 P2 that I would like try it out on.


Sent from my iPhone using Tapatalk

Was there another setting you had to change (traffic jam assist?). When just changing that setting I saw ACC but selecting it then shows "unavailable"

My traffic Jam assist was already at level 4 if I rememebr.

Will pull out the settings later today, I got the car back.

---

Here's the settings to change to enable ACC + PA for a Base model LRSM MY22 Canadian Market :

023:04
145:05

That is all.

[glennda5id]

I think the newer cars are coming with 145:05 and 314:02. Assuming your car has received a total upgrade, these settings should work well and perform better....in theory. I am still testing on my '16 XC90.

[glennda5id]

I think the newer cars are coming with 145:05 and 314:02. Assuming your car has received a total upgrade, these settings should work well and perform better....in theory. I am still testing on my '16 XC90.

I spoke too soon. On my 2016 XC90, the ECU does not like 145:05. It throws a code for incompatible configuration. Seems the ECU programming is aware of the Pilot Assist Programming which makes sense as they are all working together. I would prefer a valid ECU config, so I have had to revert 145 back to 03 (Level 2). I also tried  145:04 and that did not work.

So I am running 023:01, 314:02 and 145:03

There were no codes displayed on speedo screen/dash. Only ECU module was complaining.

[Power6]

Hey all, I have updated the original post of this thread. With the release of 0.7.7 OrBit, it now has Config Presets for PA/ACC, it will choose the right settings for you based on the car. I put in all the time to research across dozens of Volvos, so you don't have to ;-)

A good example is the discussion right above, it is confusing trying to figure out the right settings! The latest SPA are actually coming with Traffic Jam Assist, Level 3. The 2019-2021 SPA use Traffic Jam Assist Level 4. Is that a downgrade? Who knows. The latest CMA BEV models use level 4 Traffic Jam Assist. 

If you use the Config Presets, you don't have to know any of that, OrBit will get your settings right. See the first post for more info.

[maxlufter]

Hi, is it possible to activate  Curve Speed Support on German volvo v90 MY2017 ? It comes with Pilot Assist from factory, apparently version 2... but no curve speed support as it was introduced in 2020MY

[BeachBoy]

Mine is activated I have the button but have never seen it work so I have to dig into that

Sent from my Pixel 6 Pro using Tapatalk

[Duffy]

Mine is activated I have the button but have never seen it work so I have to dig into that

Sent from my Pixel 6 Pro using Tapatalk

It Works fine, only if Pilot Assist is active.



Gesendet von iPhone mit Tapatalk

[marinalin85]

Mine is activated I have the button but have never seen it work so I have to dig into that

Sent from my Pixel 6 Pro using Tapatalk

It Works fine, only if Pilot Assist is active.



Gesendet von iPhone mit Tapatalk

Mine works with ACC as well. Might be something different