ECU command FAILED when trying to set egress seat offsets

[hexaust]

I’m getting the following logs when trying to set the egress seat offsets:

Code:

Sending seat offsets write
ECU command FAILED!
Error Reason: Error setting diag session on the ECU

I’m trying this on a XC40 from 2019, the default value that is shown is 0000. I changed the 245 EASY INGRESS EGRESS to 03 With easy ingress egress retracting.

[Idle]

I’m getting the following logs when trying to set the egress seat offsets:

Code:

Sending seat offsets write
ECU command FAILED!
Error Reason: Error setting diag session on the ECU

I’m trying this on a XC40 from 2019, the default value that is shown is 0000. I changed the 245 EASY INGRESS EGRESS to 03 With easy ingress egress retracting.

Same, XC40 2020

[bananajoe]

it worked fine for me to shorten the distance on v60 2020

[Dave]

it worked fine for me to shorten the distance on v60 2020

What value did you put to shorten the distance?

[bananajoe]

so, easiest way I found was to use a hex->dec calculator, then divide the default dec value by 2, convert back to hex and enter that value.. did similar with down

[hexaust]

I’m getting the following logs when trying to set the egress seat offsets:

Code:

Sending seat offsets write
ECU command FAILED!
Error Reason: Error setting diag session on the ECU

I’m trying this on a XC40 from 2019, the default value that is shown is 0000. I changed the 245 EASY INGRESS EGRESS to 03 With easy ingress egress retracting.

Same, XC40 2020

But did you manage to get the easy entry/exit to work?