Polestar 2 charging port US-EU

[kaska3er]

Hi, anybody has attempted to do type1 to type2 charging port swap? I know that it can run on Factory OBC(charger module). Maybe some of you attempted to do this and have working 3-phase charging. I see on config position number 029 but maybe modules need to be flashed or sth. I Think same procedure will apply to every EV and PHEV vehicles.

[R1maS]

Did this yesterday - Type2, but cable from charging port to battery has to be replaced with European one. Do not ask me how to replace the cable - it has been done by the customer itself, my role was just to make the car European

[kaska3er]

Yep i know that i need to put battery off vehicle. So it’s just edit in config and 3phase type 2 is working?

[R1maS]

Yep i know that i need to put battery off vehicle. So it’s just edit in config and 3phase type 2 is working?

yep

[nelda]

i have also done this conversion a week ago. Lowered the battery and changed the cable. a lot of work but its working as it should.

[mumin]

I have a problem with the charging power in my Volvo XC90 T8 2022 USA, imported to the EU. I changed the charging socket from type 1 to type 2. In the OBC diagnostics, it correctly detects the charging cable as 16A, but it only charges with a power of 9.5-9.6A at 230V, giving me a maximum of 2.2-2.3KW. Is there a way to adjust this? Do I need to change something in the configuration or reload the OBC? (between PP and PE is 680 om - show as 20A )

[R1maS]

You have to replace the cable from charging socket to battery with eu one. Type 2 for eu is ok. No obc replace or reload is needed. At least for Polestar 2 and xc40 it is working

[mumin]

thanks, the problem is with FEYREE chargers which have a poorly selected resistor between PP and PE, after tuning it everything works correctly on one phase

does anyone have a diagram of how to connect a two-phase charger? to charge with 400V current to type 2 connector without pin L2 and L3?

[Helpful]

Need advice. I have a 2023 XC60 T8 Recharge from US with AAOS and Type 1 charging port. Accepts 16A charge and this is a maximum of 3.6 kW / h. I show you in the photo what the charging port looks like under the wing. In a 2023 car, it is different from a 2022 car and older. On my car, the wire only has a port and connectors, and that's it. There is no block like on the wire on the 2022 car. Will I be able to increase the charge to 32A and 7.2 kW / h by replacing the charging port with Type 2? What needs to be done for this?

[mumin]

as above, change the charging socket