B&W AMP and Speakers on a High Performance

[Nazsky786]

Hi,

I need help on a Bowers and Wilkins Gen 2 amp fitted to a 2017 volvo. Ive installed all the speakers but now I only get actual sound out the rear roof speakers all doors seem to be very low sound and i have issue of the indicators etc not working, they light up just no sound but the voice control talks from the rear speakers. 

Do I need to repin the speaker wires as it seems the car is the wrong way round, but I also have like 10 dtc showing up but it wont says the codes on the show drc on orbit? 

2017 high performance or basic spec to the Bowers and Wilkins 2023 Gen 2 with silver speakers.

[IMAY2023]

You should not have got gen2 B&W AUD for MY17.  The wiring of gen2 is very different.  You will need to rewire the doors, center and rear / roof speakers. 
Gen2 90 series has three channels (High, MID, LOW) on doors and dash speaker has 2 (High and MID).  
Gen2 60 series has three channels (High, MID, LOW) on front doors, 2 channels on rear doors (MID + HIGH and LOW) and dash speaker has 2 (High and MID). 
But 
Gen1 90 series has two channels (High + MID and LOW) on doors and dash speaker has 1 (High + MID).  
Gen1 60 series has two channels (High +MID and LOW) on front doors, 1 channel on rear doors (HIGH + LOW ) and dash speaker has 1 (High + MID). 
You should get yourself gen1 B&W (AUD) matching your series to avoid all the rewring and replacing the dash speaker that has two separate connectors for each channel. 


  

[BigSpell6466]

Okay, great info! 
Im about to do this same project for my V90 CC 2018 high performance with a subwoofer. So I need all the B&W speakers, the amplifier (AUD), the center speaker (dashboard speaker), and lots of wiring, right?
But I don't need to repin the AUD connector pins?

[Sodertalje]

There is some excellent information here: https://forums.spaycetech.com/showthread.php?tid=24

[Nazsky786]

Hi, Issue is I have the newer silver speaker set inc the dash 4 pin connector speaker.

I do have the door looms which have the extra wiring, question is if i can just swap it no issues as there are pins missing or added compared to both. Isn't to much of an issue to wire more cables as i want to add the rear heated seat system also, and power fold headrest. The main harness under the carpet will be a pain.

The Gen2 just sounds so much clearer and crisp, Cat B car so got all the parts needed the main loom however is damaged and cannot be used.

Its going to be a project, just need to get everything ready for the day I strip the interior.

[IMAY2023]

You also need to repin the door connector with new wires coming from the AUD. (adding the third channel to each door).

[BigSpell6466]

You also need to repin the door connector with new wires coming from the AUD. (adding the third channel to each door).

So do I also need new wires (for the third channel) all the way from the amp to the door speaker?