07-14-2025, 06:39 PM (This post was last modified: 07-19-2025, 04:56 PM by Pau1ey.)
I'd like to re-calibrate Blind Spot Information System (BLIS) & Cross Traffic Alert (CTA) as CTA is not working well when reversing even though it's enabled, and there are no DTCs. I see a few options under Additional Service Procedures but cannot find directions on how to use any of these procedures. I'm guessing that I want to choose Side Object Detection - Reset Orientation Detection in SODL(eft)/SODR(ight) as the sensors were not replaced rather than Reset SODL/SODR to Factory? Thank you!
07-19-2025, 04:53 PM (This post was last modified: 07-19-2025, 04:55 PM by Pau1ey.)
This is not as simple as beginning the procedure and driving like re-calibrating the 360 cameras - I received the following error messages, and no messages until these popped up. Unfortunately, this may be something that requires VIDA even though it's present in Orbit.
I did try starting the vehicle after clicking begin which gave me this error:
(07-19-2025, 04:53 PM)Pau1ey Wrote: This is not as simple as beginning the procedure and driving like re-calibrating the 360 cameras - I received the following error messages, and no messages until these popped up. Unfortunately, this may be something that requires VIDA even though it's present in Orbit.
I did try starting the vehicle after clicking begin which gave me this error:
we have sodL/R issues and received the same routine step 3 error.. Still searching in orbit and looking into vida..
