Adoptive cruise control is not working due to ADSM module failure, please help.

[Lim Dea woong]

The original ADSM module failed, so I replaced it with a used unit.
However, even after reset/coding attempts, Adaptive Cruise Control still does not function.
I have tested multiple used ADSM modules with the same result.
Is there a specific procedure for initializing, coding, pairing, or unlocking a used ADSM module?
Any advice would be appreciated.
Thank you.

[Sp1kE]

I had similar codes in mine "Invalid Signal". and it was a pain to figure out.

I bought a crash damaged S60 that came with no rear bumper.
The replacement bumper came with different Side Obstacle Detection modules.
When I plugged them in, I would receive these errors. The part numbers did not match and the modules were not flashed.
I didn't realize this until I paid for a 3 day Vida Subscription, where it very clearly showed a part number mismatch and wanted me to flash the modules.

My cruise still worked but those parts do not need to run cruise.
I imagine if one of the sensors/systems to run the adaptive cruise have an issue, thats why you are receiving this.

Have you replaced any modules recently? or the windshield?