Yesterday, 10:39 AM
Hi everyone,
I’m trying to add front footwell lights to my base model V60 2020 T4 Momentum, which didn't come with them from the factory. My ultimate goal is to add them to the rear too, but I haven't wired those yet. I wanted to get the fronts working first, and with time, I'll tackle the rear.
Here is what I’ve done so far:
Found the wiring: The wires and connectors were already there, tucked under the dash, so I assume they run directly to the CEM.
Bought the lights: Purchased the lights and tested them independently — they 100% work.
Plugged them in & coded: Connected them to the factory wiring and used OrBit to change the interior lighting settings. I tried changing the parameters from "Lo" to "Mid" and then to "High."
Checked Infotainment: Dug through the center screen settings to see if a toggle appeared, but couldn't get them to light up.
None of these settings have made the lights turn on. Has anyone successfully retrofitted these on a base trim? Is there another parameter in OrBit I am missing, or does the base CEM lack the pins to actually power them? Any help is appreciated!
I’m trying to add front footwell lights to my base model V60 2020 T4 Momentum, which didn't come with them from the factory. My ultimate goal is to add them to the rear too, but I haven't wired those yet. I wanted to get the fronts working first, and with time, I'll tackle the rear.
Here is what I’ve done so far:
Found the wiring: The wires and connectors were already there, tucked under the dash, so I assume they run directly to the CEM.
Bought the lights: Purchased the lights and tested them independently — they 100% work.
Plugged them in & coded: Connected them to the factory wiring and used OrBit to change the interior lighting settings. I tried changing the parameters from "Lo" to "Mid" and then to "High."
Checked Infotainment: Dug through the center screen settings to see if a toggle appeared, but couldn't get them to light up.
None of these settings have made the lights turn on. Has anyone successfully retrofitted these on a base trim? Is there another parameter in OrBit I am missing, or does the base CEM lack the pins to actually power them? Any help is appreciated!
Szigi