Hi, folks!
I have full-led headlight on my V60CC. Didn’t changed any config related to headlight.
A few month ago got CEM error message “B14C2 - Head Lamp Input - Bus signal”.
It occurs only while turning with bending being switched on. In fact light beams still operate normal and continue to bend despite the fault message.
Any ideas about reasons and possible troubleshooting?
Came across interesting bulletin. Is it possible to perform calibration with OrBit?
I have full-led headlight on my V60CC. Didn’t changed any config related to headlight.
A few month ago got CEM error message “B14C2 - Head Lamp Input - Bus signal”.
It occurs only while turning with bending being switched on. In fact light beams still operate normal and continue to bend despite the fault message.
Any ideas about reasons and possible troubleshooting?
Came across interesting bulletin. Is it possible to perform calibration with OrBit?