Polestar 2 ACC "Unavailable"

[superxpro12]

Recently bought a used 2022 Polestar with only Plus.

Got my CEM/VGM pins with no issue, and managed to enable Pixel Headlights.

I had to fuss with the VOE ethernet driver settings (particularly any driver settings having to do with green/energy savings) to fix some odd Write to Car issue, but I managed to figure it out with enough fussing.

However, when I went to use the Orbit preset to enable level 1 ACC/PA, I had a problem. After a successful Write to Car, the ACC/PA icons were now present in the IHU and the dash, but when I would attempt to engage ACC via the steering wheel, the dash would simply report "Unavailable".

After some tinkering, I discovered I had to set Adaptive Cruise Control Version 314 to "Version 2". This allowed me to successfully engage ACC. I street tested it with both follow and stop/go both performing as expected.

Since I had to change 314 to "Version 2", which is not the preset, I'm curious if anyone knows what the different versions are for?

[Power6]

Hey buddy, thank you for this. I had to check on the status of it, I was aware some cars need that item set with enabling PA/ACC. I confirmed it's included in the next update, OrBit will set this properly for the car that requires it.

[roundyuk]

I've had success with my MY2021 base spec (no Pilot) using the standard config preset with stop and go, awesome!

One thing not functioning is the stop and go with a car in front, I just come to a stop. But reading the Polestar manual I think this actually needs the creep mode to be enabled in the car (which I have off).