Front fog lights - add and activate

[tetryk92]

I plan to add front fog lights to my V90cc 2020 Sensus (originally there weren't any). I saw that there is a wiring harness behind the bumper to connect. 
Does anyone know if I need to additionally activate the halogens if I connect them? If so, will Orbit be enough for this? 
Is there any options in the Sensus menu to control the front fog lights?

[IMAY2023]

I retrofitted fog lights to my s60 2019 but the principle is the same. You should have the fog light connector on the bumper harness but most likely you won't have the wiring from the bumper harness connector to the CEM just like I did not have on mine. However, you should check that first, maybe V90cc has them pre-wired. 
The connector should be behind the wheel arch of the driver side. Count the wires coming in from the bumper and what number comes out on the other side.  
You can enable the fog lights and the cornering lights from the Orbit.  Here is a DIY video for S60 but it's just the same for yours.

[Sieluck]

My V60 recharge was the same. I was missing bumper plugs and harness to a CEM. I had to add this as well.

Wysłane z mojego CPH2581 przy użyciu Tapatalka

[tetryk92]

thanks for the replies. unfortunately I don't have the diagrams for the v90cc 2020 and I don't know what color wires to look for in the plug (there are 16 pins) to CEM. 
can anyone help with the diagrams?

[IMAY2023]

thanks for the replies. unfortunately I don't have the diagrams for the v90cc 2020 and I don't know what color wires to look for in the plug (there are 16 pins) to CEM. 
can anyone help with the diagrams?

Majority of the wiring is same as this. https://forums.spaycetech.com/attachment.php?aid=335
You also can use a simple multimeter to find the correct pins. The negative is shared by the two fog lights.

[tetryk92]

thanks for the replies. unfortunately I don't have the diagrams for the v90cc 2020 and I don't know what color wires to look for in the plug (there are 16 pins) to CEM. 
can anyone help with the diagrams?

Majority of the wiring is same as this. https://forums.spaycetech.com/attachment.php?aid=335
You also can use a simple multimeter to find the correct pins. The negative is shared by the two fog lights.

thanks for the answer. Where did you connect the ground wire from the place marked in the attachment? Is it connected to the CEM? Do you need to connect an additional pin in CEM for grounding?