08-24-2024, 03:05 PM
I’m looking for some guidance on using the Parking Camera calibration feature in OrBit. I tried this on my XC40 Recharge (MY 2023) because I felt the cameras were badly calibrated to start with. But running through the calibration process made things a bit worse. So I performed the “Learning” process, and the result is yet a bit worse. Wondering if anyone else has tried this feature on their XC40?
Here are some details:
I’m not sure if I’m doing this right, but as mentioned before, the results on my XC40 were worse than what I had before, and I don’t think there’s any way to go back to factory settings. Any help would be appreciated at this point!
Here are some details:
- From what I could understand, you first collect data by starting the monitoring process, then drive a straight as possible for “a while”. The system tells you if it’s collected enough data.
- Once you are done, you first stop the car, and you may actually have to turn it off entirely, otherwise OrBit will tell you the car is active and cannot perform any calibration.
- Calibration is used to tune cameras that had already been calibrated in the past.
- Learning is used to tune new cameras, or from what I understand, to re-initiate the calibration from scratch.
I’m not sure if I’m doing this right, but as mentioned before, the results on my XC40 were worse than what I had before, and I don’t think there’s any way to go back to factory settings. Any help would be appreciated at this point!