Alarm installation

[trasgu_driver]

Looking at the wiring diagrams, I can see that the windscreen washer system comes out of EN75 on the CEM and goes directly to the windscreen washer.

You only need to make that connection and connect it to the car’s ground. There are grounding points distributed around the car.

You can route the cable through the passenger footwell; there is a grommet there, and if I remember correctly, there is a grounding point in the wheel arch.

You can also route it through the same way I explained for the alarm cable.

Then you just activate it with Orbit.
I’m also attaching the page of the wiring diagram where this part is shown.
Let me know if you end up doing it.

Best regards.

Let me see if I understand correctly... you mean that we only need to connect EN75 of the CEM module to PIN 1 of the heated wiper and ground to PIN 2?
And what about the fuse box? Doesn't it go through there? What do you think fuses 52 and 53 are for? 
I'm just trying to understand...

EN75 of the CEM module-----------PIN 1 of the right/left heated wiper?
Groung--------------------------------PIN 2 of the right/left heated wiper?

Sorry to be such a pain...