08-16-2026, 10:56 PM
Looking at the wiring diagrams, I can see that the windscreen washer system comes out of EN75 on the CEM and goes directly to the windscreen washer.
You only need to make that connection and connect it to the car’s ground. There are grounding points distributed around the car.
You can route the cable through the passenger footwell; there is a grommet there, and if I remember correctly, there is a grounding point in the wheel arch.
You can also route it through the same way I explained for the alarm cable.
Then you just activate it with Orbit.
I’m also attaching the page of the wiring diagram where this part is shown.
Let me know if you end up doing it.
Best regards.
HEATED WIPER BLADE DRIVER SIDE.pdf (Size: 104.67 KB / Downloads: 5)
You only need to make that connection and connect it to the car’s ground. There are grounding points distributed around the car.
You can route the cable through the passenger footwell; there is a grommet there, and if I remember correctly, there is a grounding point in the wheel arch.
You can also route it through the same way I explained for the alarm cable.
Then you just activate it with Orbit.
I’m also attaching the page of the wiring diagram where this part is shown.
Let me know if you end up doing it.
Best regards.
HEATED WIPER BLADE DRIVER SIDE.pdf (Size: 104.67 KB / Downloads: 5)