BE ADVISED! VIDA detects any module replacement or addition!

[sapph940-1]

Read almost everything here, but still not 100% sure...

In my MY19 V90 i changed and configured via Orbit:

- Seats (ventilated, heated and massage)
- alarm with movement sensor
- steering wheel with heating and paddels and new SWM
- full B&W
- lock buttons for rear doors
- memory seat for passanger side

I want to go to the dealer for a last softwareupdate (Sensus 12/25).

My plan would be:
- Revert orbit to original config
- change SWM and steering wheel to original
- change AUD from B&W to original H&K
- remove memory seat buttons (unplug) on passanger side
- unplug alarm siren and movement sensor

I still have my original seats but can i just unplug them for the software update? The car will definetly have an airbag error if the seat is disconnected - that might be a problem?
Do i also have to unplug the lock buttons on the rear door?
Do i have to unplug the memory seat buttons on passanger side or is it enough to unplug the seat and revert settings in orbit?

Thanks in advance and greetings