04-11-2023, 11:30 PM
Problem solved! Now the paddles work perfectly!
In the end I don't know why but my car has been built without the 3 wires needed for the paddles....once i added the 3 extra wires everything started working as intended!
Since my car has the standard gear shift (not the shift by wire one) the procedure is a little bit different from the other one made for the shift by wire!
So here is a small "how to" for the users with standard gear shift!
1) disconnect the battery
2) remove the steering wheel and gain access to the steering harness
3) behind the steering harness you can find this connector (the 3 wires needed are the nr. 11, 12, 13 if missing you have to add them)
4) these 3 wires need to be connected into the gear shift connector (the green one)
the connection path is the following:
11=>YE/VT (gear connector cable color)
12=>BN/YE (gear connector cable color)
13=>BN/GY (gear connector cable color)
end result!
5) Done! close everything, put the new steering wheel, code with orbit and enjoy!
In the end I don't know why but my car has been built without the 3 wires needed for the paddles....once i added the 3 extra wires everything started working as intended!
Since my car has the standard gear shift (not the shift by wire one) the procedure is a little bit different from the other one made for the shift by wire!
So here is a small "how to" for the users with standard gear shift!
1) disconnect the battery
2) remove the steering wheel and gain access to the steering harness
3) behind the steering harness you can find this connector (the 3 wires needed are the nr. 11, 12, 13 if missing you have to add them)
4) these 3 wires need to be connected into the gear shift connector (the green one)
the connection path is the following:
11=>YE/VT (gear connector cable color)
12=>BN/YE (gear connector cable color)
13=>BN/GY (gear connector cable color)
end result!
5) Done! close everything, put the new steering wheel, code with orbit and enjoy!