Retrofit Volvo V60 B&W

[dawn_s]

The wiring is different from the V60 and the XC90. If you send me a photo where the amplifier connector and the wiring are clearly visible, I can explain exactly what you need to do.

Yes, the subwoofer is secured with two M6x16 screws. To install it, you need to remove a rubber plug located on the underside of the car and then fit the subwoofer into position. You can access this rubber plug once you remove the trunk side panel.

As far as I remember, I had to install the two subwoofer screws using clip nuts.

I routed the subwoofer cable through the trunk side panel, then across the car under the rear seat (fully removing it), and finally down through the right-hand door sill.

Let me know and I’ll help you.
Regards.

My vehicle is an XC60, not 90. Are the 60 series the same?
Appreciate it. I'm waiting for some connectors and an extra tweeter (the speaker set I ordered was missing one >) to come in before I tackle the rest of the job, but I really appreciate the help, so I'll reach out if I have any trouble.