(03-24-2023, 05:42 PM)Power6 Wrote: Thanks! Yes, looking at the process, it seems it's going to run a routine that should control the air suspension to set it to the "default" level. I know in VIDA it instructs you to make sure the car is in "comfort" mode, which should set the suspension to a normal height I think. So it wasn't clear exactly what will happen so a report from the field would be good!
One of the checks that is done is to make sure the car is on level ground too, at least as far as the suspension knows.
You should not need to do anything to send the logs up, though to make sure they are sent in a timely manner (Since OrBit is tolerant of you running it without Internet access) you can make sure to close OrBit when the computer has good Internet connection, or you can use the new "Send Log now" button on the "Expert" tab, to make OrBit send up the latest log, when the computer has a good Internet connection.
Then just email support and let me know to grab your log and take a look!
Well that was bad. It lowered the car down and set a suspension failure code. Does not go away on dtc clear.
Code is U2100 initial configuration not complete
Message on the dash is Suspension Failure stop safely
Car is definitely lower than comfort.
Probably on easy entry height or performance.
False alarm. It cleared itself on the way home. Carry on.
All it took was me mentally thinking F-U I’ll just get a 3 day VIDA and clear you myself. And it went away.