10 hours ago
Quote:Is there a revert to OEM function in Orbit or do i just reload from the first saved configuration?There is a revert to OEM button on the Orbit. You can use that. It will revert all the custom config back to OEM values. This is a must before the car is connected to VIDA. Otherwise, VOLVO will block the car for any software download and might also limit the diagnostic procedures because of the unauthorized configuration changes.
In general VOLVO detects only the changed configuration by third party tool (Orbit or any other) and the replaced (CAN bus, FLEXRAY and MOST) ECUs such as seat controllers, headlight controllers, AUD, SWM, BLISS, WAM and etc. However, there are some exceptions such as Alarm sensor, roof control unit that are directly connected to the CEM. The sensors or modules that are connected directly to the CEM, are detected.
Other replaced or added sensors, seat memory buttons, added heated / cooled seat modules (LIN slave ) are not detected since they are not flashable equipments.