Power Supply for Volvo V60 (2020 T4) Config Changes?

[Szigi]

Ok, tomorrow i will connect the lab power supply on 13,6V at 20A and make a read with Orbit to see how the Voltage performs, i am not ready for writing yet.





Do you think this one will be sufficient?


Best Regards JOS

I would recommended that you first connect the power supply to the vehicle and switch on the ignition. Then, measure the voltage at the tested point using a multimeter or the Orbit diagnostic tool. Allow the system to remain on for a period (e.g., 10–15 minutes), and subsequently check if the voltage value has dropped.