Seat Retrofit -- New Module is throwing codes

[Shyrik]

So, After you install your new SWM to the car and perform readout, Either heated steering wheel or reload SWM or both should show up under "Hardware changes" TAB. 
If it's both, first install the heated steering wheel.  It might already contain the SWM software in it.  
If it's only showing SWM, you will need to install it and do a new redout. You should see heated steering wheel under the functional changes.

I managed to reload the modules AUD and WAW (installed used modules).
Then I was able to upload global upgrade ( Version 3.7). I was prompted with another option how can I cheat VIDA and replace my seat modules. I downloaded the global upgrade to my computer, started installing the update, and replaced the original modules with other (used) ones. But during the installation of the VIEW, I got an error, a module mismatch. I had to install the original modules back.
The global upgrade has been successfully installed.
Then I connected an unoriginal SWM module (used with heating). Vida discovered it and invited me to download the software.
1. Heated steering wheel
2. Reload SWM
3. Reload SAS
I chose -  1. Heated steering wheel. However, during the installation process, a message appeared that the SAS module could not be restarted. I tried to do this several times, but it was all unsuccessful. The service that specializes in Volvo said that the SAS module cannot be restarted if the module has already been used.
Now all I have to do is buy a new SWM module and reload. 
I also have a desire to replace the seat modules. But I'm not sure if it will be possible to do this through a reboot of the configuration.