Seat Retrofit -- New Module is throwing codes

[Shyrik]

WAM and AUD and IMS(I don't understand why I need to reboot this module, I haven't changed it. But I have no other option.   )

If VIDA shows you those modules under HW changes TAB, this means the installed HW part numbers are different than the VOLVO DBs.  Might be the previous owner replaced them?  If not, the configuration test software might be able to clear those modules showing up in the HW change TAB. 

I would like to clarify what it means to do a configuration test. I have the ability to download this ( 31493703 configuration test ). This service costs money. I thought it would be a free service. Was I wrong?

Configuration test software is used to cost $0.10 same as total upgrade. It was a cheap fee. I am not sure if VOLVO has increased the price. 
The configuration test, reads all the module information and updates the VOLVO database and other modules installed on the car. 

I also replaced the SWM module. I had a module without heating (32230871), I installed a module with heating. (32230872). 

VIDA should have detected the change and show it under the HW changes TAB after you've replaced it. 
It might be showing as SWM reload, heated steering wheel or both. Install the heated steering wheel one first it might update the SWM. 
If none of those showing up, first install the configuration test and reread the car. It should clear up if the WAM and AUD and IMS modules are original to the car. 

Then, 
under functional changes look for the heated steering wheel reload. You can purchase and install it.

I bought the program through an intermediary, and I have to pay a much higher price than it actually costs. The upgrade costs -50 dollars, the configuration test also costs 50 dollars.
First, I want to reboot the new management modules. (WAM and AUD). And install updates.
I want to connect the SWM module to the video after these procedures, but I still haven't found any information where I can download the option to heat the steering wheel.
So far, I only see the possibility of restarting the SWM (but the update for the steering wheel will probably load without heating).
or should I also order a configuration test and replace the native seat and steering wheel modules with other modules?