Yesterday, 08:50 PM
Quote:If I revert to VIDA’s original config, I receive errors. I was told that VIDA will stop updates if it detects errors and differences between the config and the actual equipment.
Not true. If only VIDA recognises added ECUs.
First revert the car to OEM config. You mentioned that the previous owner replaced the manual seats with the electric. Under the seat you have the seat controller. Just disconnect the power connector from it. while keeping all other (air bag, occupant detection sensor, ..) connected. Disconnect the power to the WAM too. So that VIDA does not detect those modules at all.
You will get CCM DTCs "added heating seat modules" but VIDA does not care about them at all. If you want to avoid it too, just disconnect the power. Most likely the previous owner used a fuse tab under the glove box.