Today, 12:11 AM
Hi all! I’m running into the same issue others have mentioned where I attempt to start the suspension calibration but it fails to actually run and the car now has a suspension fault which must be cleared by driving.
Are there specific steps which need to be done in order to successfully run this calibration? Do I need to have anything specific in the suspension turned on or off?
Just looking to lower the ride height by 20-25mm but I can’t even get to that stage.
The vehicle is a 2018 XC90 T8.
Thanks in advance!
Are there specific steps which need to be done in order to successfully run this calibration? Do I need to have anything specific in the suspension turned on or off?
Just looking to lower the ride height by 20-25mm but I can’t even get to that stage.
The vehicle is a 2018 XC90 T8.
Thanks in advance!
XC90 T8 Inscription aka Dolph
Previous Volvos
XC60 T5 Platinum
240 DL Sedan Turbo 5speed
240 DL Sedan 5 Speed
Previous Volvos
XC60 T5 Platinum
240 DL Sedan Turbo 5speed
240 DL Sedan 5 Speed

