Yesterday, 07:13 PM
There is no coding for the sensors after replacement. The sensors are connected to the CEM, check the guide I posted earlier.
Most likely you have wiring issues.
Each sensors has 3 wires. 2 of those wires are common. (ground, positive) the third middle one is the signal. Get a multi meter and check the wires if they short or have continuity end to end.
The pumber harness should have a connecter on the driver side behind the wheel arch. Rear bumper harness has a connector at the right side. From those connectors wires go to the CEM.
Most likely you have wiring issues.
Each sensors has 3 wires. 2 of those wires are common. (ground, positive) the third middle one is the signal. Get a multi meter and check the wires if they short or have continuity end to end.
The pumber harness should have a connecter on the driver side behind the wheel arch. Rear bumper harness has a connector at the right side. From those connectors wires go to the CEM.