03-24-2023, 03:42 AM
(03-23-2023, 10:53 PM)Power6 Wrote: So yeah, what Partridge said ;-)
Calibration is needed when say the height the suspension "thinks" it is at, for each corner, is not the height it is "actually" at. The process in VIDA and coming to OrBit, will help you measure and figure out if that is the case, then calibrate.
Further though, the *real* ask for this, was those who want to say... "lower" the car 10mm or so, if we recalibrate the suspension to a "custom" height you can do that. Previously this was done by calibrating with VIDA and "fooling" the measurement process. I will make it more straightforward for those who want to do that.
OrBit v.4.0.0 is released now...so anyone with air suspension...try the calibration! On the new "Service" tab. It will only run some checks (log a ton of stuff for me to look at) and I beleive, also set the car at "default" height, but you guys let me know on that, and when you run it, let me know! support -at- spaycetech d0t com. So I can review your logs. I will use the info to properly build out the rest of the process.
I’ll give it a try tomorrow when I can find a nice level spot to test it. I assume that what you mean by set it to default you mean it’ll move the car into position to be measured? Do we need to do anything special to send the logs to you?
Sent from my iPhone using Tapatalk