03-19-2023, 03:39 PM
FYI I am about halfway through integrating the "Suspension Calibration" process. It's a bit of a bear to work all the parts out. However, the VIDA log is great, it has the height measurements entered and the original specs compared. So I definitely have the info for the XC60 already. At the core of it, the process is not complicated, a "calibration string" is created, and written to the SUM. The steps to get to that point are where the "work" is: a number of checks VIDA does to verify the car is on level ground, not on a lift, not jacked up, the system is enabled and working etc, then having you measure the heights and input them.
This may or may not "make" the next update. When it does it will probably be "experimental" will need people to test it. I don't think it's much of a worry about messing anything up, just test getting through the process without any OrBit errors. Ultimately we are just writing small "offsets" to the SUM to trim the heights of each wheel. I am sure I can make an easy interface to handle the desired "lowering" while you do the calibration as normal, without need to do any math in your head like "fooling" VIDA.
This may or may not "make" the next update. When it does it will probably be "experimental" will need people to test it. I don't think it's much of a worry about messing anything up, just test getting through the process without any OrBit errors. Ultimately we are just writing small "offsets" to the SUM to trim the heights of each wheel. I am sure I can make an easy interface to handle the desired "lowering" while you do the calibration as normal, without need to do any math in your head like "fooling" VIDA.