07-28-2025, 08:50 PM
You should not have got gen2 B&W AUD for MY17. The wiring of gen2 is very different. You will need to rewire the doors, center and rear / roof speakers.
Gen2 90 series has three channels (High, MID, LOW) on doors and dash speaker has 2 (High and MID).
Gen2 60 series has three channels (High, MID, LOW) on front doors, 2 channels on rear doors (MID + HIGH and LOW) and dash speaker has 2 (High and MID).
But
Gen1 90 series has two channels (High + MID and LOW) on doors and dash speaker has 1 (High + MID).
Gen1 60 series has two channels (High +MID and LOW) on front doors, 1 channel on rear doors (HIGH + LOW ) and dash speaker has 1 (High + MID).
You should get yourself gen1 B&W (AUD) matching your series to avoid all the rewring and replacing the dash speaker that has two separate connectors for each channel.
Gen2 90 series has three channels (High, MID, LOW) on doors and dash speaker has 2 (High and MID).
Gen2 60 series has three channels (High, MID, LOW) on front doors, 2 channels on rear doors (MID + HIGH and LOW) and dash speaker has 2 (High and MID).
But
Gen1 90 series has two channels (High + MID and LOW) on doors and dash speaker has 1 (High + MID).
Gen1 60 series has two channels (High +MID and LOW) on front doors, 1 channel on rear doors (HIGH + LOW ) and dash speaker has 1 (High + MID).
You should get yourself gen1 B&W (AUD) matching your series to avoid all the rewring and replacing the dash speaker that has two separate connectors for each channel.