Quote:Do I need to connect them one by one to do the reload or can I leave these two modules connected at once?You can have them both connected. If the replacement units have the same HW number, there is a chance that VIDA would not show them in the HW changes TAB. If it detects, you can order and install them one after another. The order does not matter.
What you need to do is.
Restore all config to OEM from Orbit
1) Connect the original PSMD and PSMP to the seats.
2) Connect the VIDA and do a readout.
3) Check the HW changes TAB under the Software Installation main PAGE. If you see the AUD or WAM or both. Since you put the original PSMD and PSMP, they should not show up there.
4) Order and install AUD and WAM if they show up in the HW changes TAB.
5) Order and install total upgrade.
6) Perform fresh readout from VIDA.
7) Order Configuration change and retrieve but do not hit on install yet.
8) Replace the PSMD and PSMP with the new ones. While VIDA is connected and ready to install the configuration change.
9) Click on install the configuration change.
10) Do a fresh reload, at this point, VIDA should not show the PSMD and PSMP under HW changes. If they do appear, this means VOLVO has changed the logic. You will need to put the original PSMD and PSMP back and reorder and reinstall the configuration change So that, VIDA removes the detected HW changes from the VOLVO servers.
Configuration change app, scan the car for any equipment and software config changes and reports back to VOLVO servers updating their systems.